Filling The Clean-Water Tank - Numatic TTB 4045/100 Mode D'emploi

Filling the clean-water tank

The TTB / ETB Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single
fill.
Fig.21
Note.
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
To fill the clean-water tank, use the 1 meter FLEXI - FILL pipe from either a tap or hose
pipe (Fig.21).
The large cap can also be unscrewed for filling from a bucket or suitable
container.
Fill the clean-water tank to a maximum of 40 litres, including cleaning chemicals if
required.
Follow chemical manufacturing guide lines.
The clear dump hose at the rear of the
machine can be used to see the level of the
clean water.
100%
28
Machine Set-Up