Foot Controller - Tecno-gaz TYGI 350 B Manuel D'utilisation

INSTRUCTIONS FOR USE

Foot controller

8.2
left top button
– getting-on position
left bottom button
– optional function
- start with continuous control
- starting position (flushing)
left top button
– getting-on position
left bottom button
– optional function
- start with continuous control
- starting position (flushing)
With the micromotor and turbine instruments, when the button with optional function CHIPBLOWER is pressed on the
foot controller cooling air will blow through the instrument tips.
Foot controller pedal/lever serves to put the instruments into operation, while with the micromotor, turbine it is possible
to control the micromotor and tubine rotations by moving the lever of the foot controller (from 0 up to the value set on the
display); and with the scaler, cauter, by moving the foot controller lever it is possible to control the output (from 0 up to
the value set at the display).
The buttons GETTING-ON POSITION, MEMORY POSITION and CROSS SWITCH TO CONTROL THE CHAIR are
intended to control the dental chair.
Memory positions are recalled by pressing the button MEMORY POSITION + movement of the cross controller –
upwards = , downwards =
The second pressing / movement of the cross controller must be made within two seconds after pressing the button
MEMORY POSITION, else the position will not be recalled.
UM_EN_TYGI350B_2018-09_ver1.0
lever
pedal
UNO
NOK
TYGI 350 B
right top button
–recalling of memory position of
the chair
right bottom button
- optional function
cross switch
-to control the chair
cross switch
-to control the chair
right top button
–recalling of memory position of
the chair
right bottom button
- optional function
37 / 49