Tecno-gaz TYGI 350 B Manuel D'utilisation page 131

INSTRUCTIONS FOR USE
When a parameter is changed, while the instrument is taken out of its holder, without subsequent pressing the button
, the changed parameter will be saved only temporarily. The change will remain saved until the instrument
program has been changed (Prog 1 – 9).
The change will be maintained ever after the dental unit has been turned on /off. To cancel the temporary setting, press
the button and select the current program.
Data will be over-written with the data from the memory for the said program. To save the change of the parameter
permanently into the respective program, press the button
To activate the micromotor, take it and move the foot controller lever to the right and/or the press the pedal of the
combined foot controller. When moved to the extreme position, the micromotor has the ouput displayed. To stop the
activity, move the lever (pedal) of the foot controller to the starting position. Following the termination tool automatically
goes blow through for 0.5 seconds. CHIPBLOWER function is recommended to use after the activity has been finished.
The micromotor output can be set by means of the buttons + / - within the range of 0-100% with the instrument taken in
rest or in operation and the lever /pedal of the foot controller is in maximum position. When working with the instrument,
the output can be adjusted continuously by pedal or by the lever of the foot controller in the analogue mode from 0 up to
maximum set value.
After the operation time of the micromotor has reached the lubrication interval, the instrument lubrication alarm
displayed and audible signal sounds. This will be repeated each time the instrument is used until the information about
lubrication need is cancelled by pressing the button OK in the alarm screen.
Assign function to the left / right side button of the foot controller at instrument control
Pressing of left/right side icon of the button opens „pop-up menu" with the offer of functions. Select desired
function by pressing the appropriate button. Press „ESC" button if you want to cancel. You can setup both:
LEFT/RIGHT side buttons of the foot controller. You can choose only those functions, which are available
for the current tool. The others are disabled.
Availability of individual symbols on the display and options of setting of individual parameters and their limits
depends on the type of the motor used. Before using the instrument, it is recommended to make yourself
familiar with the performance of the instruments, according to the data from the instrument manufacturer.
Retraction of procedural water
Upon the termination of use of dental instrument (after release of the foot controller pedal/lever),
dental unit software automatically performs blowing of instrument head (micromotor, turbine) using cooling air
of the instrument in a duration of 0.5 seconds.
UM_EN_TYGI350B_2018-09_ver1.0
Chipblower function
Cooling of instrument ON/OFF
Changing of the direction of motor rotation
Instrument illumination ON/OFF
Main light ON/OFF
Bell
Cup filling
Bowl flushing
No function chosen
Switching the program of the instrument
Switch color of the instrument light (white/blue) (applies to motors:
DENSIM DX BLUE, DENSIM DX PRO BLUE)
.
after the change
TYGI 350 B
is
30 / 49