Tecno-gaz TYGI 350 B Manuel D'utilisation page 113

INSTRUCTIONS FOR USE TYGI 350 B
Chair movement
The basic movements of the chair are controlled by using of the buttons with the symbols of the direction of movement.
The movement is performed while the button is kept pressed and is indicated by an additional indicator depending on
the orientation of the movement , , , . All the said buttons control the chair directly with the instruments
placed in position or with an instrument taken while the pedal of the foot controller is in zero position.
Programmable positions.
These serve to save and recall pre-set positions of the chair.
The units enables two arbitrary user positions: ,
and two special-purpose positions :
/ Rinsing position / Return from rinsing position
Getting-on position
Press the respective button to recall the desired position.
Programming positions
To program the position into the memory, set the chair to desired position and then press and hold the button for the
said position for at least 2 seconds.
Getting into program mode is indicated by beeping and changing of the colour of the button frame. After the button has
been released the position is written to the memory.
All programable positions are saved separately for each user and are recalled from the memory automatically when the
user has been selected.
12 / 49
UM_EN_TYGI350B_2018-09_ver1.0