Tecno-gaz TYGI 350 B Manuel D'utilisation page 136

INSTRUCTIONS FOR USE
By pressing on appropriate program, the program is included
via foot controller side button.
If the foot controller function P# has been chosen, then by repeated pressing of this button, all the included
programs are being switched cyclically towards sequentially higher program number. After the included program
achieves highest position number, then it again gets position with lowest sequential number.
Button for editing the program name.
Press and hold the button for ca 2 seconds. Alphanumeric keyboard is displayed by means of which the
text can be edited. Maximum length of the text is 20 characters.
Button for the selection of operation mode.
The button is active only for instrument that enables it. Press the button to display a „pop-up" with the
mode options (depending on instrument type):
Press the respective button to select the desired mode or cancel the selection of the mode by pressing the button „ESC".
If you want to save the new mode permanently into the memory, first press the button of saving into the memory
The new condition of saving the data into the memory is indicated by change in the colour of the icon
the condition, press the button again.
Button for setting the amount of cooling water.
Press the button to start the setting mode in which the buttons whose values can be changed are displayed
in red. Change the parameter value by means of the buttons +/- . The new value is saved temporarily
(until the change of the program number) by pressing the button of the parameter being set again or
permanently into the program by means of the button
keyboard after pressing the button
Button to turn the instrument light on / off.
Press the button to turn the instrument illumination on -
question.
Button to change the operation mode of the pedal / lever of the foot controller.
The button is active only if the output control mode is enabled. It indicates the discrete mode of the pedal,
i.e. after pressing the foot controller pedal / lever, the controlled quantity jumps to maximum set values and
does not change any more with the pedal position. By pressing the button the following is displayed:
Pedal in analogue mode
After pressing the foot controller pedal / lever, the controlled quantity increases proportionally to the deviation
of the foot controller pedal / lever up to the maximum value at the full deviation of the foot controller pedal /
lever. The button is active only if the instrument is at rest.
Button to turn the instrument cooling on / off.
Press the button briefly to turn the instrument cooling on/off. When a parameter is changed, while the
instrument is taken out of its holder, without subsequent pressing the button
parameter will be saved only temporarily. The change will remain saved until the instrument program has been
changed (Prog 1 – 9).
The change will be maintained ever after the dental unit has been turned on /off. To cancel the temporary setting, press
the button and select the current program. Data will be over-written with the data from the memory for the said
program. To save the change of the parameter permanently into the respective program, press the button
.
the change
Button to correct the patient position
Press the button briefly to display the screen to control the basic movements of the chair and then the
patient position can be corrected. To return, press the button ESC or activate the instrument. It is still
possible to correct patient position (while instrument is activated) with the basic moves of the chair via foot
controller.
When a parameter is changed, while the instrument is taken out of its holder, without subsequent pressing the button
UM_EN_TYGI350B_2018-09_ver1.0
. The new value can be entered also directly via numerical
. The button is active only if the instrument cooling is turned ON.
or excluded from programs switching
/ off - ,if it is possible for the instrument in
, the changed
TYGI 350 B
.
. To cancel
after
35 / 49