Tecno-gaz TYGI 350 B Manuel D'utilisation page 129

INSTRUCTIONS FOR USE
achieves highest position number, then it again gets position with lowest sequential number.
Button for editing the program name.
Press and hold the button for ca 2 seconds. Alphanumeric keyboard is displayed by means of which the
text can be edited. Maximum length of the text is 20 characters.
Button for the selection of transmission ratio of the handpiece.
Press the button to display a „pop-up menu" with transmission ratio options:
Press the respective button to select the desired transmission ratio or cancel the selection of transmission ratio by
pressing the button „ESC". If you want to save the new value of the transmission ratio permanently into the memory, first
press the button of saving into the memory
change in the colour of the icon
Button for setting the motor torque.
Press the button to start the setting mode in which the buttons whose values can be changed are
displayed in red. Change the parameter value by means of the buttons +/- .
The new value is saved temporarily (until the change of the program number) by pressing the button of
the parameter being set again or permanently into the program by means of the button
in the mode ENDODONTIC.
Button for the selection of the motor operation mode NORM / AREV / AFWD
Mod normal – Normal
MX(BLDC) motor is controlled as a standard micromotor, except that the rotations can be set and it is
possible to set the torque.
*Pos. Auto-reverse mode - AREV
After reaching the set limit torque, the micromotor starts to rotate in the opposite direction (counter-clockwise rotations)
until the foot controller has been released. Reverse running is indicated by flashing of the instrument light.
*Pos. Auto-forward mode - AFWD
After reaching the set limit torque, the micromotor starts to rotate in the opposite direction (counter-clockwise rotations),
namely until it has been released, then it remains in the said direction for the set time, e.g. AFt = 3,5 s and then return to
the original rotations (clockwise rotations). This is repeated until the foot controller has been released. The reverse running
is indicated by flashing tool and audible indication during the ATf. In this mode the reverse timecan be set within the range
of 0,1 – 5 seconds by 0,1 second.
Press the button to display a „pop-up menu" with the mode options:
Press the respective button to select the desired motor oeprationmode or cancel the selection of the mode by pressing
the button „ESC". If you want to save the new mode permanently into the memory, first press the button of saving into the
memory .
The new condition of saving tzhe data into the memory is indicated bny change in the colour of the icon
the condition, press the button again. The button is active onlyif the instrument is at rest.
Button of setting the time for the mode AUTOFORWARD.
Press the button to start the setting mode in which the buttons whose values can be changed are displayed
in red. Change the parameter value by means of the buttons +/- . The new value is saved temporarily
(until the change of the program number) by pressing the button of the parameter being set again or
UM_EN_TYGI350B_2018-09_ver1.0
. The new condition of saving the data into the memory is indicated by
. To cancel the condition, press the button again.
NORM
AREW
AFWD
ESC
TYGI 350 B
. The button is active only
. To cancel
28 / 49