Motor Submerged In Water; Cold Weather Precautions; Checking After Striking Underwater Object - TOHATSU MFS 25B Manuel De L'utilisateur

Masquer les pouces Voir aussi pour MFS 25B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENOM00105-0

5. Motor submerged in water

After taking your outboard motor out of the
water, immediately take it to your dealer.
The following are the emergency measures
to be taken for a submerged outboard
motor, if you can not take it your dealer
right away.
1. Wash the outboard motor with fresh
water to remove salt or dirt.
2. Remove the engine oil drain screw and
completely drain water and oil from the
engine.
3. Remove the spark plugs, and com-
pletely drain the water from the engine
by pulling the recoil starter several
times.
Replace oil filter and oil to the correct
level.
The oil and filter may need to be
changed again after running a short
period to get all moisture completely
out of the crankcase.
4. Inject a sufficient amount of engine oil
through the spark plug holes.
Pull the recoil starter several times to
circulate the oil throughout the out-
board motor.
ENOW00098-0
CAUTION
Do not attempt to start submerged out-
board motor immediately after it is recov-
e r e d , o r e n g i n e c o u l d b e s e v e r e l y
damaged.
INSPECTION AND MAINTENANCE
ENOM00106-0

6. Cold weather precautions

If you moor your boat in cold weather at
temperatures below 0°C (32°F), there is
the danger of water freezing in the cooling
water pump, which may damage the
pump, impeller, etc. To avoid this problem,
submerge the lower half of the outboard
motor into the water.
ENOM00107-0
7. Checking after striking
underwater object
Striking the sea bottom or an underwater
object may severely damage the outboard
motor. Immediately bring the outboard
motor to the dealer and ask for the follow-
ing checks.
1. Looseness or damage of power unit
installation bolts, gear case and exten-
sion case bolts, propeller shaft housing
bolts, propeller or propeller shaft upper
and lower mount rubber bolts, and/or
mount bracket bolts.
Ask an authorized dealer to tighten any
loose bolts and nuts, and to replace dam-
aged parts.
2. Damage to mount rubber, the tilt stop-
per, thrust rod, gears and clutch, and/
or propeller.
Ask an authorized dealer to replace dam-
aged or defective parts.
71

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mfs 30bMfs 25Mfs 30

Table des Matières