20
INSTALLATION
ENOM00024-0
1. Mounting the outboard motor on
boat
ENOW00006-0
WARNING
Most boats are rated and certified in terms
of their maximum allowable horsepower,
as shown on the boat's certification plate.
Do not equip your boat with an outboard
motor that exceeds this limit. If in doubt,
contact your dealer.
Do not operate the outboard motor until it
has been securely mounted on the boat in
accordance with the instructions below.
ENOM00025-0
Position ... Above keel line
Set engine at center of boat.
1. Center of boat
2. Boat transom
ENOM00026-0
Transom matching
Be sure that the anti ventilation plate of the
outboard motor is 5–25 mm (0.2–1 in)
below the bottom of hull.
If the above condition cannot be met due
to the shape of the bottom of your boat,
please consult your authorized dealer.
1
2
ENOF00014-0
2
1. Bottom of hull
2. Anti ventilation plate
ENOM00027-0
MF, EF, EP type
1. To attach the outboard motor to the
boat, tighten the clamp screws by
turning their handles.
Also, use the bolts to secure the out-
board motor brackets on transom
board.
Secure the outboard motor with a rope
to prevent loss overboard.
ENON00002-0
Note
A rope is not included in the standard
accessories.
1
1. Bolt (8 × 85)
2. Nut
3. Washer
4. Clamp screw
ENOW00007-0
CAUTION
Before beginning the running test, check
that the boat with maximum capacity
loading floats on the water in a proper
1
5−25 mm
(0.2−1 in)
ENOF00015-0
2
3
4
ENOF00016-0