Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor; Storing The Outboard Motor - TOHATSU MFS 25B Manuel De L'utilisateur

Masquer les pouces Voir aussi pour MFS 25B:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00070-0

1. Removing the outboard motor

1. Stop the engine.
2. Disconnect the fuel connector, the
remote control cables and the battery
cords from the outboard motor.
3. Remove the outboard motor from boat
and completely drain the water from
the gear case.
ENOW00064-0
CAUTION
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow engine to cool down before attempt-
ing to carry the outboard.
ENOM00071-0

2. Carrying the outboard motor

Keep the outboard motor in a vertical posi-
tion when carrying.
ENOW00065-0
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
Do not give a shock to an outboard
motor during transportation. It becames
a cause of breakage.
ENOM00072-0

3. Storing the outboard motor

Outboard motor should be stored in a ver-
tical position.
ENON00021-0
Note
If the outboard motor must be laid down be
sure the tiller handle faces down as shown
in the drawing above.
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
ENOW00066-0
Do not carry or store outboard motor in any
of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
ENOF00071-0
WARNING
CAUTION
ENOF00072-0
51

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mfs 30bMfs 25Mfs 30

Table des Matières