Setting The Temperature; Warning Functions Or Temperature Limit - Julabo SW22 Mode D'emploi

Switching on

7.1. Setting the temperature

Notice:
When the working temperature is higher than 50 °C, it might happen that due to
strong production of steam there is considerable dripping on the inside of the
lift-up Makrolon
tempered.
 Always properly seal all sample containers.

7.2. Warning functions or temperature limit

 )..)..)..)
66
Display and adjustment of the working temperature:

Press the setpoint key
The indicator light blinks and the value previously set appears
on the MULTI-DISPLAY (LED).
(example: 25.0 °C).

If no further key is pressed the display will return to show the
actual bath temperature after approx. 8 seconds.

Use the cursor keys
display until the numeral you wish to change is blinking.

Use the increase/decrease arrows
selected numeral (0, 1, 2, 3, ... 9).

Press enter
(example: 38.0 °C).
The working temperature is maintained constant after a short heat-
up time (e. g. 38.0 °C).

cover. Some drops may fall directly into the material to be
More protection for your samples in the bath!
As soon as the actual temperature leaves one of the pre-adjusted
limits, this status is evaluated.
The high- and low-temperature limit can be evaluated in two ways
(see page 75).
1. As pure warning function with an acoustic signal in regular
intervals. (Signal - Pause)
2. As temperature limit by switching-off the heating and alarm.
.
to move left or right on the
to store the selected value
to change the