Commissioning; Adjusting Of Temperature Setpoint; Display Off - Julabo PURA 4 Mode D'emploi

Commissioning

7 Commissioning
Pos: 15 /T echnische Dokum entation/Flash CORIO/PURA/Einstellm enü @ 1\mod_14 640 893 857 99_1 8.docx @ 9 742 @ 2 @ 1
7.1

Adjusting of temperature setpoint

Setpoint
settings
Example:
Danger from mains voltage.
Risk of injury from electric power.
•
Compare the mains voltage and frequency with the details on the
model plate.
• Connect the device only to a safe power supply via FI-circuit
breaker (IA = 30 mA).
• The device may only be connected to power outlets with a ground
contact (PE – protective earth).
• The mains plug serves as a safe disconnecting device from the
power supply network and must be freely accessible at all times.
• Do not start the device if it has a damaged mains cable.
•
Check the mains cable regularly for signs of damage.
•
We disclaim all liability for damage caused by incorrect line
voltages!
Device settings
Switch-on the unit ->
Press -> indication of the actual value
The temperature can be set in the start/stop condition.
The set value is saved so that it will be retained even after a power outage.
1. Press the edit key
value to the desired value. The decimal point will flash.
2. Change the value:
Press the key to set a higher value.
Press the key to set a lower value.
Press the key briefly for single steps, press and hold the key to adjust
the values quickly.
3. Save the set value as the desired value by pressing the
4. The new desired value will flash three times.
5. A signal sounds once the setpoint is
display
or briefly to switch from displaying the actual
reached.
OFF
28. 5
key.
37