Evaluation Of The Temperature Limits; Safety Installation (With Shutdown Function) - Julabo SW22 Mode D'emploi

8.7. Evaluation of the temperature limits

9.

Safety installation (with shutdown function)

))))

The high- and low-temperature limit can be adjusted in two ways
(see page 66)
3. As pure warning function with an acoustic warning signal in
regular intervals.
Adjustment „Li 0" – factory adjustment
4. As temperature limit by switching-off the heating. Adustment „Li
1"
The alarm is indicated by optical and audible signals
(continuous tone) and on the MULTI-DISPLAY (LED) appears
the error message "Error 01".
1.
Press and
2.
Use the cursor keys
Limit. (example: „Li 0").
3.
Select the alternative state with the edit keys
confirm the selection with the ENTER key
1").
4.
Press and
(excess temperature protection)
These safety installations is independent of the control circuit.
When the temperature of the bath liquid has reached the safety
temperature, a complete shutdown of the heater and pump (only
CW-models) is effected.
The alarm is indicated by optical and audible signals (continuous
tone) and on the MULTI-DISPLAY (LED) appears the error
message "Error 01".
Shaking Water Baths
at the same time.
to select the menu option
at the same time.
and
(display „Li
75