List Of Commands - Julabo SW22 Mode D'emploi

12.2. List of commands

Command Parameter
version none
status none
out_mode_05 0
out_mode_05 1
out_mode_08 0
out_mode_08 1
out_mode_09 0
out_mode_09 1
out_sp_00 xxx.x
out_sp_02 xxx.x
out_sp_03 xxx.x
out_sp_16 xxx.x
in_sp_00 none
in_sp_02 none
in_sp_03 none
in_sp_16 kein
in_pv_00 none
in_pv_01 none
Response of the shaking water bath
Number of software version(V X.xx)
Status message, error message (see below)
STOP - returns the water bath to the „OFF" state
START - water bath is switched to the operating state
Circulator pump „OFF"
Circulator pump „ON"
Shaking operation drive motor „OFF"
Shaking operation drive motor „ON"
Set working temperature„T"
Set high temperature warning limit
Set low temperature warning limit
Set shaking frequency
Ask for working temperature „T"
Ask for high temperature warning limit
Ask for low temperature warning limit
Ask for shaking frequency
Ask for actual bath temperature
Ask for the heater wattage being used
Shaking Water Baths
81