Electronic Timer - Julabo SW22 Mode D'emploi

7.4. Electronic timer

))..))..))

The electronic timer enables adjustment of the operating time up
to a maximum of 9 hours and 59 minutes. Countdown then
commences to zero, at which time an acoustical time signal will
be issued in intervals
(double signal - pause).
- t h e e q u i p m e n t w i l l n o t b e s w i t c h e d o f f -
Display and adjustment of the operating time:

Press the key
The indicator light blinks and and the MULTI-DISPLAY (LED)
will display the remaining operating time (example: 4.28 h:m).

If no further key is pressed the display will return to show the
actual bath temperature after approx. 8 seconds.

Use the cursor keys
MULTI-DISPLAY (LED) until the numeral you wish to change is
blinking.

Use the edit keys
numeral value (0, 1, 2, 3, ... 9).

Press enter
commence. During that time the monitor lamp (control lamp)
will remain permanently illuminated.
When the operating time is expired an acoustical time signal is
issued in intervals.
Cancellation of the time signal:
Press enter to silence the time signal.
Notes:
1. Following switch-on of the equipment and after a power
failure, the timer will show 0:00 h:m.
2. When the equipment is operating remotely controlled the timer
is rendered inoperative.
.
to move left or right on the
to increase or decrease the
to store the value when the countdown will
Shaking Water Baths
69