Julabo SW22 Mode D'emploi page 61

always be fully covered with the bath fluid!
• Never operate the unit without bath fluid in the bath.
• Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
• Never operate damaged or leaking equipment.
• Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or
before moving the unit.
• Transport the unit with care.
• Sudden jolts or drops may cause damage in the interior of the unit.
• Always empty the bath before moving the unit.
• Never operate equipment with damaged mains power cables.
• Observe all warning labels.
• Never remove warning labels.
• Condensation that could appear in and on other units near the water bath
may result in reduced operating safety.
Be careful when setting up and operating the water bath!
• Always turn off the unit and disconnect the mains cable from the power
source before cleaning the unit.
• Repairs are to be carried out only by qualified service personnel.
 Some parts of the bath cover may become extremely warm during
continuous operation.
When lifting the bath cover, pay attention to hot steam!
 Be careful when touching these parts!
 Use safety glasses!
Shaking Water Baths
59