Julabo SW22 Mode D'emploi page 50

Abridged Manual - SW22 / SW23
 Acoustical signals and their differentiation
Three different signals are generated by the sound generator as follows:
an alarm signal, a warning signal and a time signal
The signals can easily be recognized and differentiated, even from a good distance.
))))


)..)..

))..))..
Menufunctions
Selecting/exiting the menu level.
• Simultaneously press the cursor key
• Use the cursor keys
• Select the alternative state with the edit keys
the ENTER key
• Simultaneously press the cursor key
Temperature indication
Futher menu options see operating manual.
ATC - „Absolute Temperature Calibration"
Setup for remote control
Adjusting interface parameters
Circulator pump ON/OFF (only SW23)
Shaking operation ON/OFF
Evaluation of the temperature limits
48

The Alarm signal is a continuous sound signal.
Heater and circulator pump (only SW23) are completely and
permanently switched

The warning signal is issued at regular intervals
(signal - pause - signal - pause).
The actual bath temperature is higher than the set
overtemperature value or lower than the set undertemperature
value

The time signal is issued in the intervals
(double signal - pause - double signal - pause).
Countdown of the adjusted operating time commences to zero,
after which a time signal is issued at intervals
to select the menu option.
in °C
off.
and enter .
and confirm the selection with
and enter .
or in °F