Setup For Remote Control - Julabo SW22 Mode D'emploi

8.5. Setup for remote control

If the shaking water bath is to be remotely controlled or monitored,
the parameter of the menu option REMOTE must be changed and
set from 0 to 1.
REMOTE 0 = Keypad control
1 = Remote control via RS232 interface
1.
Press and
2.
Use the cursor keys
REMOTE
(display „r 0").
3.
Select the alternative state with the edit keys
confirm the selection with the ENTER key
The shaking water bath will switch to the REMOTE „STOP"
condition and the MULTI-DISPLAY will show the message
„OFF".
4.
Press and
Shaking Water Baths
at the same time.
to select the menu option
at the same time.
and
(display „r 1").
73