Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation page 7

6. Apply epoxy to the outside of the hinge using a toothpick.
Insert the hinges into the control surface after applying the
epoxy. Verify the hinge position is correct.
7. Use a paper towel and isopropyl alcohol to remove any
excess epoxy. Allow the epoxy to fully cure before proceeding.
8. Mix 1/2 ounces (15mL) of 30-minute epoxy. Use a toothpick
to apply epoxy inside each of the holes for the hinges.
9. Apply epoxy to the outside of the hinge using a toothpick
10. Fit the elevator to the stabilizer. Check that the control surface
can move freely, and the hinges are all aligned properly. Use
a paper towel and isopropyl alcohol to remove any excess
epoxy.
OV-10 Bronco 30cc
11. Use low-tack tape to hold the elevator in position until the
epoxy fully cures.
7 EN