Nose Gear Retract Installation - Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation

NOSE GEAR RETRACT INSTALLATION

98. Use a hobby knife and #11 blade to remove the covering for
the nose gear retract in the fuselage.
99. Mount the steering servo in the retract servo opening using
four M3 x 12 button head screws. Apply a drop of threadlock
on each screw, then tighten the screws using a 2mm hex
wrench.
100. Assemble the steering linkage and attach it to the servo using
an M3 x 12 button head screw, M3 washer and M3 lock nut.
Use a 2mm hex wrench and 5.5mm nut driver. Snap the ball
on the steering arm of the retract. Center the steering servo
and adjust the length of the linkage to center the nose gear.
 Make sure to adjust the servo travel so equal
defection is achieved in each direction. Also make
sure the servo is not over traveling as this may
damage the ball attached to the nose leg.
101. Use small pliers to snap the e-clip in the groove in the nose
gear axle. Slide the axle into the nose gear wheel fork.
102. Apply a drop of light machine oil in the hole in the wheel.
OV-10 Bronco 30cc
103. Slide the wheel in position, then use the remaining e-clip to
secure the axle.
104. The completed assembly for the nose gear can be mounted in
the fuselage one the servo and wheel are installed.
105. Mount the nose gear in the fuselage using four M4 x 25
button head screws, an M4 lock washer and M4 lock nut.
Tighten the hardware using a 2.5mm hex wrench and 7mm
nut driver. Use a rubber band across the sides of the fuselage
to apply a very small amount of tension of the steering servo
lead. This will keep the lead from accidentally getting into the
retract mechanism during the operation of the retract.
19 EN