Horizon Hobby HANGAR 9 OV-10 Bronco 30cc Manuel D'utilisation page 31

187. Fit the gun pods in position on the fuselage.
188. Attach the gun pods using two M4 x 10 socket head cap
screws, two oversized M4 washers and an M4 lock washer.
Tighten the screws using a 3mm hex wrench.
189. Attach the drop tank to the drop tank pylon using two M4 x
10 socket head cap screws and two M4 lock washers.
 Do not overitighten the hardware. Doing so may damage
the pylon or the mounting area within the drop tank
 A long 3mm hex wrench will be required
to tighten these screws.
190. Attach the drop tank pylon to the bottom of the fuselage using
two M4 x 10 socket head cap screws, two oversized M4
washers and an M4 lock washer. Tighten the screws using a
3mm hex wrench.
 Do not overitighten the hardware. Doing so may damage
the pylon or the mounting area within the fuselage.
OV-10 Bronco 30cc
191. Locate the blind nuts in the outer panels for the missile
pylons. The rear blind nut is 2 inches inside the aileron servo
cover, and 1-inch forward of the front edge of the aileron
servo cover. The forward blind nut can be located using the
missile pylon.
192. Attach the missile pylon to the bottom of the outer wing panel
using two M4 x 10 socket head cap screws and two M4 lock
washers.
 Do not overitighten the hardware. Doing so may damage
the pylon or the mounting area within the wing
 A long 3mm hex wrench will be required
to tighten these screws.
193. Attach the missile to the missile pylon using two M4 x 10
socket head cap screws and two M4 lock washers. Use a
3mm hex wrench to tighten the screws.
 Do not overitighten the hardware. Doing so may damage
the pylon or the mounting area within the wing. Check
alignment of screws as it is possible to cross thread
the screws into the blind nuts in wings. Adjust as
required: these screws should tighten up easily.
 Attach the remaining missile at this time.
31 EN