Yamaha FJR1300AP 2010 Mode D'emploi page 44

A-A
A
1 Rear flashing light stay
2. Rear turn signal light
3. Rear turn signal light lead
4. Plastic band (L = 108.5 mm)
5. Clamp
6. Wire lead
7. Rear bracket
8. Tail cover
A. Install in alignment with the top edge of the
rear bracket.
B. The connected leads must not be located
below the rear fender.
C. Route the rear turn signal light lead on the
outside of the bolt.
D. Clamp the rear turn signal light lead on the
top of the rear bracket. Face the end of the
plastic locking tie outward.
E. The clamp ends facing inward.
F. The clamp ends facing outward.
RECOMMENDED SPECIFICATIONS
B-B
B
B
D D
C C
C C
A
C-C
D
38
D-D