Yamaha FJR1300AP 2010 Mode D'emploi page 20

1. Extension wire lead
2. Wire lead (for battery charging)
3. Negative lead (for battery charging)
4. Coupler (for battery charging)
5. Fuse (SUB)
6. Clamp
7. Wire harness
8. Coupler (for speaker)
9. Negative battery lead
10. Starter motor lead
11. Stay
12. Wire harness assembly
13. Horn lead
14. Fan lead
15. Wire lead
A. Clamp the wire lead, the negative battery
lead, the starter motor lead on the battery
box. Clamp the wire lead on the white tape
marking section and turn the clamp end to-
ward the rear.
B. To the headlight lead
C. Remove the battery positive lead and con-
nect the sub-harness for recharge.
D. Clamp the wire harness assembly, nega-
tive battery lead and starter motor lead.
E. Route the wire harness assembly along the
front side of the frame and clamp the white
tape marking section of harness at the top
of the hole in the frame. Set the clamp end
inward without cutting it off.
14
MAINTENANCE
A-A
A
A