Yamaha FJR1300AP 2010 Mode D'emploi page 19

1. Right grip warmer lead
2. Right handlebar switch lead
3. Hazard switch lead
4. Front brake hose
5. Guide
6. Left handlebar switch lead
7. Left grip warmer lead
8. Clamp
9. Throttle cable (accelerator cable)
10. Throttle cable (decelerator cable)
A. Route the hazard switch lead, right handle-
bar switch lead and grip warmer lead under
the handlebar.
B. Route the hazard switch lead and grip
warmer lead over the right handlebar
switch lead while taking care not to have
them pinched between the guide and right
handlebar switch lead.
C. Route the left handlebar switch lead and
the grip warmer lead under the handlebar.
D. Pass the clutch hose, the handlebar switch
leads (left and right), the grip warmer leads
(left and right) and the hazard switch lead
through the guide.
E. Clamp the hazard switch lead and right
handlebar switch lead. Do not clamp the
grip warmer lead.
F. Clamp the hazard switch lead, right handle-
bar switch lead, grip warmer lead, main
switch lead and immobilizer unit lead.
G. Pass the front brake hose, the right handle-
bar switch lead, the right grip warmer lead,
the hazard switch lead, the throttle cable
through the guide.
H. Clamp the grip warmer lead on the throttle
cable. Fasten the clamp where 10 mm in-
side of the rubber boot end and cut off the
clamp end.
13
MAINTENANCE