Yamaha FJR1300AP 2010 Mode D'emploi page 22

1. Wire harness assembly
2. Wire lead
3. Rear combination light lead
4. Rectifier/regulator
5. Rectifier
6. Clamp
7. Rectifier/regulator lead
8. Neutral switch lead
9. Main harness
10. Sub-lead wire
11. Rear frame
A. Connect the coupler having the wire lead
ID tape on it to the main harness.
B. Clamp the neutral switch lead, rectifier/reg-
ulator lead and sub-lead wire.
C. Route the sub-lead wire inside the main
harness.
D. Put the clamp tip on the inside of the frame.
E. Outside
A
A
F. Route the rear combination light lead on
the outside of the vehicle.
16
MAINTENANCE
A-A