Yamaha FJR1300AP 2010 Mode D'emploi page 21

1. Right handlebar switch lead
2. Hazard switch lead
3. Grip warmer lead
4. Wire harness assembly
5. Clamp
6. Stay
7. Coupler (for siren)
8. Radiator hose
9. Coolant reservoir hose
10. Front wheel sensor lead
A. Connect the right handlebar switch lead to
the wire harness assembly.
B. Connect the hazard switch lead to the wire
harness assembly.
C. Clamp the handlebar switch lead, the grip
warmer lead and the hazard switch lead,
and pass them through the hole of the stay.
Set the clamp end downward without cut-
ting it off.
D. Clamp the wire harness assembly, hazard
switch lead, handlebar switch lead and grip
warmer lead. Do not clamp the front wheel
sensor lead.
E. Clamp the handlebar switch lead, the grip
warmer lead, front wheel sensor lead and
the hazard switch lead, and pass them
through the hole of the stay. Set the clamp
end downward without cutting it off.
F. Route the wire harness assembly outside
the coolant reservoir hose and radiator
hose.
G. Route the wire harness assembly along the
front side of the frame and clamp the white
tape marking section of harness at the top
of the hole in the frame. Set the clamp end
inward without cutting it off.
15
MAINTENANCE