Installation And Removal Of The Rotor; Eba 200; Eba 200 S - Hettich EBA 200 Mode D'emploi

EN
12

Installation and removal of the rotor

12.1

EBA 200

B
A
12.2

EBA 200 S

The rotor may only be installed and removed by Customer Service.
52/146
Installation:

Clean the motor shaft (A) and the bore of the rotor and then apply a
thin coat of grease to the motor shaft. Dirt particles between the
motor shaft and rotor prevent the rotor from having a perfect seat and
cause it to run unsteadily.

Place the rotor vertically onto the motor shaft. When putting on the
rotor, the marking beam (B) on the rotor must be parallel to both
surfaces (C) on the motor shaft.

Tighten the clamping nut of the rotor with the Allen wrench (included
in delivery) by turning clockwise.

Check the rotor to make sure it is seated firmly.
C
Removal:

Loosen the rotor's clamping nut by turning counter-clockwise with the
Allen wrench (included in delivery) and turn up to the lifting pressure
point. After overcoming the lifting pressure point, the rotor is released
from the cone of the motor shaft. Turn the clamping nut until the rotor
can be lifted up from the motor shaft.

Lift up the rotor from the motor shaft.
Rev. 05 / 05.2020 AB1800DEENFRIT