Battery Operation - Medela Freestyle Mode D'emploi

2
Slide the country-specific plug
onto the larger adapter unit
(if this is not already done so).
Plug the plug into the mains
socket on the wall. The motor
unit is now ready for operation.
3
Charge the battery by con-
necting the motor unit to the
mains. "bAtt" will appear on
the display on the motor unit's
front. Charge the battery until
the battery indicator on the dis-
play stops flashing and "bAtt"
disappears. The battery is now
fully charged. Disconnect the
mains adapter. The pump is
ready for operation via battery.

6.2 Battery operation

1
To operate the pump via
battery, open the battery
compartment by pressing the
push-button on the battery
cover (on the back of the motor
unit) and sliding the cover in
the direction of the arrow.
Mains adapter
connected to socket
Battery charge status
flashing
Battery fully charged, approx.
3 hours' expression
20 min. expression time remaining.
flashing
Battery flat
flashing
Initial charge and charging after
"bAtt" removing the battery
(up to 24 hours charging time)
The above table shows the different
operation statuses. These symbols appear
on the display on the front of the motor unit.
19 19