Working With The Machine; Irregularities, Incidents, Accidents; Maintenance And Repairs; Protection Of Environment - Solo 434 Instructions D'emploi

2.9 Working with the machine

While running, the engine produces toxic exhaust gas which is odourless and invisible. Never start or
operate the machine in closed rooms. Ensure for adequate ventilation in confined areas such as
ditches or dips. Remain within calling distance to other persons who would be able to provide assistance if
needed. Provide for regular and in-time rest periods.
Do not smoke in the vicinity of the machine or at the work site. Smoking increases the danger of fire!

Operate the machine with as little noise and exhaust gas emission as possible - only run the engine
when necessary. Consider that noise is an environmental hazard. Respect and observe any quiet
periods which may vary locally.

Do not touch the muffler and exhaust while still hot. Danger of burns!

Never operate the machine without a muffler or with a damaged muffler. Danger of burns and loss of
hearing!

The machine should be stopped when not in use and secured to prevent danger of injury to others.

2.10 Irregularities, incidents, accidents


In case of irregularities, leaks, visible damage or reduced efficiency, do not commence work, but leave
the unit from a dealer check.

When irregularity, leaks or malfunctions occur during operation, turn off the stop switch immediately
and put the machine on the ground immediately. The device may only be used again if it is checked by
a specialist workshop and the cause of the fault has been eradicated.

In case of serious disturbances or accidents during operation of the unit as smoke, strong odors from
the device or the device is in flames instantly remove the unit from your body and take a safe distance.
In case of fire, you have to call the fire department immediately.

2.11 Maintenance and repairs

The power tool must be serviced on a regular basis. Only perform maintenance work or repairs yourself if
the work is described in these operating instructions. All other work must only be performed by an
authorised workshop

Do not maintain, repair or store the machine in the vicinity of an open flame.

Always stop the engine before attempting any cleaning, repair or maintenance jobs. An exception is
the adjustment of the carburettor or idling speed.

Only remove the pressure hose (14), the trigger handle (15), the spray wand (17) and the nozzle insert
(18) when the engine has been switched OFF and the system is fully depressurised. To achieve this,
with the engine switched OFF, insert the spray wand (17) into the liquid tank or into a container
suitable for the liquid concerned, and operate the trigger handle (15).

For any repairs only use original parts from the manufacturer.

Do not modify, alter or change the machine as this may impact on the safety of and with the machine
and lead to accidents and injury!

2.12 Protection of Environment

Be aware of your surroundings!

Watch out for persons and animals which may be within your work area

Be aware that noise is harmful to the environment. Inquire about and respect possible local rest
periods.

Avoid contaminating the environment, the mains water supply and/or public sewer systems with
spraying agent, cleaner, fuel and oil! Ensure to avoid contamination when mixing, filling, using,
draining, mixing and filling-in the fuel mixture, cleaning, servicing and transporting by using adequate
procedures and suitable containers.

When applying spraying agent, ensure by using appropriate measures and procedures that the
unintended release of agent to other areas is minimized and the drift to the surrounding areas is
prevented.
Safety regulations
ENGLISH 7