Solo 434 Instructions D'emploi page 29

Liquid volume
Prepare spray liquid according to the requirements
of the chemical manufacturer. Match the spray
volume to the actual requirement.
General volume data for plant protection:
 Ground plants 0,3-0,5 l for 10 m
 Low shrubs and bushes 1,0-1,5 l for 10 m
 Trellis crops, spindle bushes 0,5-1,0 l each
 Larger bushes 2,0 l each
Preparation of spray chemicals
repare plant protection chemicals in the open air,
never in living areas, stables or storage areas for
food stuff or fodder.
Plant protection chemicals in powder form:
 Prepare the spray mixture in a separate
container. Do not prepare the mixture in the
chemical tank of the machine!
 Mix the solution well, then pour into the
chemical tank of the high pressure sprayer. Use
the tank inlet filter!
 Use the spray wand to stir the spray solution in
the chemical tank of the machine.
Plant protection chemicals in liquid form:
 Fill chemical tank of machine ¼ with water,
 Pre-mix spray chemical with water in separate
container according to the instructions of the
chemical manufacturer,
 Pour pre-mixed spray chemical into the
chemical tank of the high pressure sprayer. Use
inlet filter.
 Add water according to the instructions of the
chemical manufacturer.
 Stire the spray solution in the spray tank with
the spray wand.
Biological spray solutions should be poured
through a strainer before pouring the solution into
the spray tank via the inlet filter. This will prevent
repeated clogging of the inlet filter.
Preparation of spray chemicals, filling of liquid container
2
2
spraying agent tank without first thoroughly
cleaning the tank and all parts that come into
contact with the spraying agent and flushing the
system with plenty of clean water.
Recommendation: Use the special SOLO cleaner
for plant protection sprayers (dosing bottle of
500 ml [approx. 16.9 oz], part no.: 49 00 600).
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
Identification of the tank
contents:
Attach the relevant
sticker to the spraying
agent tank to indicate the
contents of the tank (i.e.,
herbicide, fungicide or
insecticide).
The designation of the
spraying agent used has
to be attached to the
device and has to be
updated every time when
the spraying agent is
changed.
CAUTION:
Never fill different spraying agents into the
ENGLISH 11