Stiebel Eltron DHE Connect 18 Utilisation Et Installation page 87

INSTALLATION
Standard installation
4 Strainer
5 Plastic profile washer
f Secure the tee and 3-way ball shut-off valve, each with a flat f
gasket, to the twin connector.
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing an appliance, check whether the f
strainer is installed.
Installing the appliance
Note
If you are installing the appliance with flexible water
connections, also secure the back panel with a screw.
1 Cable entry installation aid
2 Cable grommet
www.stiebel-eltron.com
1
2
Use the installation aid for easier wiring access through the cable
grommet (see plastic parts set supplied).
f Remove the cable grommet from the back panel. f
f Pull the cable grommet over the cable sheath of the power f
cable. For large cable cross-sections, enlarge the hole in the
cable grommet if necessary.
f Remove the transport protection plugs from the water f
connections.
f Bend the power cable 45° upwards. f
f Route the power cable and cable grommet through the back f
panel from the rear.
DHE Connect | DHE Touch | 87