Stiebel Eltron DHE Connect 18 Utilisation Et Installation page 93

INSTALLATION
Alternative installation methods
CAUTION Burns
If the water supplied to the appliance is preheated, the
internal anti-scalding protection and the temperature
limit that is adjustable by the user may be exceeded.
In such cases, limit the temperature with an upstream
central thermostatic valve (ZTA 3/4).
Anti-scalding protection deactivation
f Proceed as described under "Anti-scalding protection acti- f
vation". Deactivate anti-scalding protection by tapping the
"Active" tick symbol (deactivate).
14.2 Electrical connection from above on unfinished
walls
1 Cable routing
www.stiebel-eltron.com
f Reposition the mains terminal from the bottom to the top. To f
do this, undo the fixing screw. Turn the mains terminal with
connecting cables 180° clockwise. Route the cable around
the cable guide when doing so. Secure the mains terminal in
place.
f Replace the cable grommets by removing both cable f
grommets.
f Install the cable grommet from the top at the bottom. f
f Route the other cable grommet over the cable sheath of the f
power cable. Pull the cable grommets into the back panel
until both locking tabs engage.
f Install the appliance on the threaded studs of the wall f
mounting bracket.
f Push the back panel firmly against the wall. Lock the fixing f
toggle by turning it 90° clockwise.
f Pull the cable grommets into the back panel until both lock- f
ing tabs engage.
f Connect the power cable to the mains terminal. f
1
DHE Connect | DHE Touch | 93