Yamaha E8D Manuel D'utilisation page 148

4-16
4) Reinstall the filter element in the cup.
Make sure the O-ring is in position in
the cup. Firmly screw the cup onto the
filter housing 4.
5) Attach the filter assembly to the bracket
so that the fuel hoses are attached to
the filter assembly.
6) Run the engine and check the filter and
lines for leaks.
EMU09912
INSPECTING IDLING SPEED
w
8 Do not touch or remove electrical
parts when starting or during opera-
tion.
8 Keep hands, hair and clothes away
from flywheel and other rotating parts
while engine is running.
cC
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can also
be used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with
the outboard motor in the water.
1) Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly. If the outboard motor is mounted on
a boat, be sure the boat is tightly
moored.
E