Inspecting And Replacing Anode(S) - Yamaha E8D Manuel D'utilisation

8D
001482
9.9F, 15F
4-23
000274
9.9D, 15D
604034
001262
1) Empty the fuel tank into an approved
container.
2) Pour a small amount of suitable solvent
in the tank. Reinstall the cap and shake
the tank. Drain the solvent completely.
EMU04020
Cleaning the Fuel Filter
1) Remove the screws holding the fuel
hose joint assembly. Pull the assembly
out of the tank.
2) Clean the filter (located on the end of
the suction pipe) in a suitable cleaning
solvent. Allow the filter to dry.
3) Replace the gasket with a new one.
Reinstall the fuel hose joint assembly
and tighten the screws firmly.
EMU14622
INSPECTING AND REPLACING
ANODE(S)
Yamaha outboard motors are protected
from corrosion by sacrificial anodes. Inspect
the external anodes periodically. Remove
scales from the surfaces of the anodes.
Consult a Yamaha dealer for replacement of
external anodes.
cC
Do not paint anodes, as this would ren-
der them ineffective.
NOTE:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and replace-
ment of internal anodes attached to the
power unit.
E