Installation; Connection Of The Mains Adapter; Switching On And Self Test; Disconnection Of Mains Supply - Enraf Nonius Sonopuls 190 Mode D'emploi

7.1. Connection of the mains adapter

• Connect the supplied mains adapter to the con-
nector [1].
• Connect the mains adapter to a wall socket.
The flashing dot in the upper display [9] indi-
cates that the unit is connected to the mains
supply and stand-by.

7.2. Switching on and self test

• Switch on the unit using the On/Off button [2].
• Immediately after switching on, the unit carries
out a self test.
Check that:
• All LED's light up briefly.
• At the end of the test a beep can be heard.
Contact your supplier if this is not the case.
8. DISCONNECTION OF MAINS
• Switch the Sonopuls 190 of with the on/off but-
ton [2].
• Unplug the mains adapter from the wall socket.
• Disconnect the mains adapter from the
Sonopuls 190.
20

7. INSTALLATION

SUPPLY