Indications And Contra-Indications; Indications; Absolute Specific Contra-Indications; Relative Specific Contra-Indications - Enraf Nonius Sonopuls 190 Mode D'emploi

5. INDICATIONS AND CONTRA-
Please refer to the optional therapy book.

5.1. Indications

• conditions affecting joints, bone, muscle tissue;
• rheumatoid arthritis (not acute);
• affections of the peripheral nerves;
• affections of the blood circulation;
• affections of the internal organs;
• affections of the skin, scar tissue;
• Dupuytren's contracture;
• open wounds, decubitus ulcer, post-traumatic
conditions.

5.2. Absolute specific contra-indications

• eyes;
• heart;
• pregnancy;
• epiphysial discs;
• brain tissue;
• testicles.

5.3. Relative specific contra-indications

• status post laminectomy;
• loss of sensation;
• endoprostheses;
• tumours;
• post-traumatic sequelae;
• thrombophlebitis and varices;
• septic inflammation;
• diabetes mellitus.
INDICATIONS

6.1. APPARATUS

(see fold-out sheet at front)
[1] Connector for mains adapter
[2] On/Off button
[3] Treatment time display
[4] Treatment time buttons
[5] Intensity display
[6] Display function button (W/cm² or W)
[7] Intensity buttons
[8] Program button
[9] Display duty cycle ultrasound and program
[10]Duty cycle button
For the connection of the mains adapter.
With this button the Sonopuls 190 is turned
on or off.
When there is adequate ultrasound contact,
the timer will count down to zero. If the ultra-
sound contact becomes inadequate, the timer
stops automatically (a flashing dot in the dis-
play indicates that the clock is running).
These buttons are used to set the treatment
time. Treatment times below 10 minutes can
be set in intervals of half a minute by using the
button.
Depending on the choice of display function,
this display shows intensity (W/cm²) or the
power (W). The setting flashes and/or a sound
signal is audible (if turned on) as long as there
is no adequate acoustic ultrasound contact
(contact control).
Switches the display function between inten-
sity (W/cm²) and power (W).
These / buttons are used to set the in-
tensity. The maximum intensity can be set from
zero by one touch on the
With this button the selection of the program
modus is selected. To select one of the pre-
programmed suggestions press one of the
buttons [7] within 2½ seconds. The indication
P1 - P9 is visible in the display [5]. After approx.
2 seconds the treatment parameters are dis-
played and treatment can be started.
number
Display of the set duty cycle (= ratio pulse du-
ration - pulse interval) and program number.
This button is used to set the duty cycle (5,
10, 20, 50, 80 and 100 %).

6. CONTROLS

button.
19