Before Use; Before First Use; Setting The Clock - ETNA SM344RVS Mode D'emploi

BEFORE USE

Before first use

Setting the clock

• Open the door, remove the packaging and check the microwave
for damage.
• Do not use the microwave if it is damaged, but contact your
supplier.
• Remove the protective film from the casing.
• Clean the oven interior and accessories with a damp cloth. Do not
use any abrasive cleaner or strong-smelling cleaning products.
• Place the turntable in the centre of the oven cavity with the opening
for the drive shaft facing downwards. The microwave may not be
used without the turntable.
When the appliance is connected to the network for the first time, you
need to set the time. '00:00' flashes in the display. The clock runs as
long as the microwave is connected to the network.
1. Turn the selection dial to set the current time
(between 00:00 and 23:59).
After setting you will hear a beep and the time display will stop
flashing. The clock has been set.
Remarks
• If you wish to reset the time at a later stage, you must first press
and hold the clock button for a few seconds. The current time will
disappear and the time display will then start to flash.
• Turn the selection dial to set the new time and press the clock
button again to confirm.
If you do not wish to see the time in the display, press the clock
button briefly. The time display will disappear. Press the clock
button briefly again to display the time again.
EN 7