Use; Before Use - ETNA SM125RVS Mode D'emploi

USE

Before you begin
Setting the clock
Do's and don'ts
• Open the door and remove the packaging material. Do not
install the microwave oven when it is damaged, but contact the
manufacturer.
• Remove the protection foil from the outside of the microwave
oven.
• Clean the inside of the oven and the accessories with a damp
cloth. Do not use abrasive cleaners or any strongly smelling
detergents.
• Place the roller stay in the middle of the microwave oven. The
turntable must be placed on the driving mechanism with the
indentation for the driving mechanism downwards.
• Check if the microwave oven is working correctly. Put a glass of
water inside the oven space. Switch the microwave oven on for
1 minute on its highest setting (press the start button
After 1 minute, the water should be hot.
The clock will work as long as the oven is connected to the mains. If
the time has not been set, the display will show '0:00'.
Setting the clock
1. Press button .
In the display the hour figure will flash.
2. Turn the control knob to set the hours.
3. Press button again.
In the display the minute figure will flash.
4. Turn the control knob to set the minutes.
5. Press button again to confirm the setting.
The clock is set and the ':' will flash.
The door may be opened when the microwave oven is switched on;
press button , the microwave oven switches off and the cooking
stops. Open the door. After closing the door, press the start button
to start the cooking again.
EN 10

Before use

twice).