Before Use; Before You Begin; Setting The Clock - ETNA cm644ti Mode D'emploi

BEFORE USE

Before you begin

Setting the clock

• Open the door and remove the packaging material.
• Do not use the microwave oven when it is damaged, but contact
the manufacturer.
• Remove the protection foil from the outside of the microwave oven.
• Clean the inside of the oven and the accessories with a damp cloth.
Do not use abrasive cleaners or any strongly smelling detergents.
• Place the turntable in the middle of the microwave oven with the
indentation for the driving mechanism downwards.
• The microwave oven may not be used without the turntable.
When the power is first supplied to the microwave oven, you must set
the clock. In the display '00:00' will blink. The clock will work as long as
the microwave oven is connected to the mains.
1. Use the selection buttons to set the time (between 00:00 and
23:59).
After you have set the right time, you will hear a beep and the time
stops blinking. The clock has been set.
Notes
• If you want to change the time later on, you have to press and hold
the clock button. The actual time will blink in the display.
• Use the selection buttons to set the time and then press the clock
button again to confirm.
EN 7