Sharp R-68ST Mode D'emploi page 224

R-68ST_EN.qxd 7/27/07
To promote trouble-free use of your oven
and avoid damage.
Never operate the oven when it is empty except
where recommended in the operation manual, see
Page GB-7. Doing so may damage the oven.
When using a browning dish or self-heating
material, always place a heat-resistant insulator
such as a porcelain plate under it to prevent
damage to the turntable due to heat stress.
The preheating time specified in the dish's
instructions must not be exceeded.
Do not use metal utensils, which reflect microwaves
and may cause electrical arcing. Do not put cans
in the oven.
Use only the turntable designed for this oven.
Do not place anything on the outer cabinet during
operation.
Do not use plastic containers for microwaving if the
oven is still hot from using the GRILL, DUAL
GRILL and AUTOMATIC operation (except AUTO
DEFROST), because they may melt. Plastic
containers must not be used during above modes
1. Remove all packing materials from the inside of the
oven cavity. Discard the loose polythene sheet from
between the door and cavity. Remove the feature
sticker, if attached, from the outside of the door.

Remove this film
2. Check the oven carefully for any signs of damage.
3. Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked. Do not place the
oven in a cabinet.
12:20 PM Page 3
IMPORTANT SAFETY INSTRUCTIONS
unless the container manufacturer says they are
suitable.
Do not use the utensils which touch the oven cavity
wall and door during cooking. Use the utensils
which turn smoothly in the oven during cooking.
Use the utensils which are smaller than the
turntable (275mm diameter).
NOTE:
If you are unsure how to connect your oven, please
consult an authorised, qualified electrician.
Neither the manufacturer nor the dealer can accept
any liability for damage to the oven or personal
injury resulting from failure to observe the correct
electrical connection procedure.
Water vapour or drops may occasionally form on
the oven walls or around the door seals and
sealing surfaces. This is a normal occurrence and is
not an indication of microwave leakage or a
malfunction.
This symbol means that the surfaces are
liable to get hot during use.
INSTALLATION
4. The oven door may become hot during
cooking. Place or mount the oven so that
the bottom of the oven is 85 cm or more
above the floor. Keep children away
from the door to prevent them burning
themselves.
5. Do not allow the power supply cord to
run over any hot or sharp surfaces,
such as the hot air vent area at the top
rear of the oven.
6.Ensure there is a minimum of free space above the
oven of 18 cm.
7. Securely connect the plug of the oven to a
standard earthed (grounded) household electrical
outlet.
GB-3
18 cm