WARNING
Keep the working area clean.
Do not use pressurised water jets to wash the machine
You are strongly advised not to use compressed air to clean moving components.
During cleaning operations, try as far as possible to prevent dust from forming or
rising.
To make your machine last longer and perform better, it is recommended to:
- clean the turntable and the guide pins once a week with environmentally friendly
solvents;
- grease (fig�52) all of the machine's moving parts at least once a month;
- clean the filter cartridge approx� every 1500 hours of operation;
- check the oil level in the power unit (fig�53), from the wet rod to the plastic cap there
must be 5cm / 2 inch� Top up with API CIS 32 / AGIP OSO 32 oil or another equivalent
type if necessary� The check must be performed with the cylinders "closed" placing the
cap on the tank, without tightening it�
It is recommended to replace the oil in any case after 1500 hours of operation or once
a year�
MANUFACTURER
AGIP
ESSO
FINA
SHELL
API
CAUTION
Any top-ups or fluid changes using fluid of qualities different from those indicated may
reduce the machine's lifetime and impair its performance.
WARNING
Any operation intended to modify the maximum pressure setting value of the relief
valves or pressure limiter is forbidden.
The manufacturer declines all liability for damage resulting from tampering with
these valves.
66
TYPE OF OIL
OSO 32
NUTO H32
HYDRAN 32
TELLUS OIL 32
CIS 32
Operator's manual MONSTER AGTT
ARNICA 68
INVAROL EP 68
IDRAN HV 68
TELLUS T OIL 68
HS 68