Corghi MONSTER AGTT Manuel D'utilisation page 64

The distributor leaks
• Replace the distributor
Gaskets worn
• Replace the gaskets
Overload cut motor protector activated
• Open the electrical board, set the main switch to 0 and then use the specific key to
reactivate the overload cut motor protector, operating the switch (fig�51); when complete,
reclose the electrical board�
No power supply to the solenoid valve
• Check the solenoid valve's electrical connection
The control lever does not operate the machine
• Contact Technical Assistance
Batteries run down (yellow LED on)
• Charge the batteries
• Contact Technical Assistance
Pump broken
• Replace the pump
Worn connection joint
• Replace the joint
Not enough oil
• Top up the oil
Switch on control lever defective
• Replace the switch
Identify and remove the source of the radio disturbance
Contact technical assistance to change the transmission channel
Simultaneous movement of 2 cylinders; a solenoid valve is probably locked
• Clean or replace the solenoid valve
• Contact technical service to adjust the sliding blocks
64
Turntable cylinder pressure drop
Motor stops during use
The machine does not move
No hydraulic pressure
Excessive control unit noise
Jerky movements
Presence of radio interference
Excessive trolley clearance.
Operator's manual MONSTER AGTT