Electrolux AFP8 Série Mode D'emploi page 63

822_949_311 AFP850-880_EX.book Seite 63 Dienstag, 22. Januar 2008 8:57 20
Inserting tools
The following tools can be selected for
insertion:
• Whisking disk (fig. 1/R) or
• Metal blade (fig. 1/Q) or
• Plastic blade (fig. 1/P) or
• Insert holder (fig. 1/O) with cutting
insert (fig. 9)
3 The insert holder must be fitted with
the appropriate insert depending on
the purpose of application (see "Insert-
ing cutting insert in insert holder").
0 Place desired tool on spindle.
– Whisking disk, metal blade and plas-
tic blade (fig. 8) mesh with the teeth
underneath on the spindle.
– The insert holder (fig. 11) rests on
the hexagonal spindle.
Preferably hold the insert holder with
3
two fingers in the two handle holes.
Fitting the cover (fig. 6)
0 Place cover (fig. 1/F) on the all-purpose
bowl (arrow
turn counter-clockwise to the stop.
The cover can be heard to engage. The
nose of the cover is then directly above
the handle, both black arrows must
coincide.
0 Insert stopper (fig. 1/E) in filling inlet.
Inserting cutting insert in insert
holder (fig. 10)
The appropriate insert must be placed
in the insert holder depending on use.
3 The inserts are contained in the hinged
accessories compartment (fig. 1/K) in
the motor casing.
1 The inserts are very sharp. They should
be held only with the handle!
0 Open accessories compartment by
pulling the handle (fig. 9).
0 Take required insert by the handle from
the accessories compartment (fig. 9).
0 Place the insert with the tip at the cen-
0 To remove the insert draw slightly out-
Operating multifunction section
0 Open cover (fig. 1/F) and place all
3
1
0 Start the appliance: turn speed selector
on arrow ) and
3
1
0 Switch off appliance: turn speed selec-
0 After using, turn cover clockwise and
1
0 Remove the tool and spindle.
0 Turn the all-purpose bowl clockwise
tre of the insert holder and place in the
recess of the disk (fig. 10).
wards with the handle and raise.
ingredients required in the all-purpose
bowl.
Caution: Do not exceed maximum fill-
ing volume:
– liquid 1.75 litres
– solid 1.5 litres
Further ingredients can be added dur-
ing operation through the filling inlet.
The filling beaker in the stopper (fig.
1/E) can also be used for this purpose.
Close the filling inlet immediately each
time to avoid splashes.
Use the stopper exclusively to com-
press the cutting items!
(fig. 1/l) right to the desired speed set-
ting or press the pulse button (fig. 1/J).
It is recommended to start at a slow
speed and then to increase the speed.
The appliance operates at maximum
speed by pressing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
If the warning lamp (fig. 4/a) flashes
and the appliance cannot be started,
the safety cover for the mixer drive
(figs. 1/T and 4) is not properly fitted.
tor left to the "0" position.
remove.
Only remove the cover when the tool
has come to a complete stop!
and remove.
g
63