Vacuum Packing; Setting The Device - Steba SousVide SV1 Mode D'emploi

Before using for first time:
∙ The device must be properly cleaned before it is filled with water.
∙ Thoroughly clean container with hot water and a little washing up liquid, rinse and
wipe dry.
∙ Attention! Do not immerse electrical part in water!
∙ Only wipe inside of lid with a damp cloth and dry.

Vacuum packing

Only use bags that are suitable for vacuum packing. There is no guarantee of proper
closure if normal bags are used. Ensure that there are no spices in the vicinity of the
weld seam, otherwise hermetic sealing will not be possible.
vacuum sealer VK5:
foil bag: 22 x 30cm:
foil bag: 28 x 40cm:
foil roll: 22 x 500cm:
foil roll: 28 x 500cm:

Setting the device

Display
Temperature
Indicator lamp
∙ Press On/Off button
pears in display. Press the Temperature-Button one time, in display appears „40C".
Set required temperature using the +/- button. Press the Timer button
play shows 00:01 hour. By pressing the +/- button the desired time can be adjusted.
By pressing the Start/Stop button
press = steps of 1 minute, long button press = fast forward. The maximum time
setting is 24 hours
∙ When the device is operating the indicator lamp illuminates.
Art No 05-05-00
Art No 93-30-00
Art No 93-40-00
Art No 93-22-00
Art No 93-28-00
for at least 2 seconds. The button illuminates „0000" ap-
the appliance can be started. Short button
EAN: 4011833301819
EAN: 4011833400574
EAN: 4011833400581
EAN: 4011833400550
EAN: 4011833400567
Time
Start / Stopp
On / Off
scale 1:1
, the dis-
11