Setting Function "Motion Det - Sygonix 700 TVL Mode D'emploi

i) Setting function "MOTION DET"
So movements in the monitoring area can be recognized more easily, you can mark a maximum
of four rectangular areas.
If a movement is detected in one of these areas, this frame fl ashes to attract your attention to
the movement.
"DETECT SENSE"
"BLOCK DISP"
"MONITOR AREA"
"AREA SEL"
We recommend that you either use inversion (select the area as described above) or select a
maximum of four rectangles, which fl ash briefl y when a movement is detected. You should not
activate both marking functions at the same time.
28
The home technology brand for the entire house. More information at www.sygonix.com
Sensitivity for motion detection
"ON": The image areas in which there is movement are displayed alternately,
briefl y inverted. This increases the visibility, especially when there is varying
image content.
"OFF": No inversion
"ENABLE": Press the button, to display a cross-hatch pattern. At the point
where the cross-hatch is visible, a brief inversion of the image content occurs
when there is a movement (see above under "ON").
To exclude certain image areas from the inversion (if it would be a nuisance),
move the coloured cursor with the button to the left, right, up or down.
Press the button again briefl y, and the cross-hatch disappears from the cur-
sor fi eld (or reappears if you press the button again). Erase as much of the
cross-hatch as needed, until the only area in which the pattern is visible is the
one that is to be displayed later inverted (see "ON").
Leave the cursor mode, by pressing and holding the button for 2 seconds
and then releasing it. The setup menu is now displayed again.
"ON": Only the area set with "BLOCK DISP/ENABLE" (see above) is monitored
and presented inverted, in the case of a movement.
"OFF": If "BLOCK DISP" is set to "ON", image inversion occurs for the whole
image when motion is detected. This can be used, for example, for testing in
order to set the sensitivity of the motion detector.
If "BLOCK DISP" was switched to "OFF", the image area saved under „AREA
SEL" is disabled during monitoring.
Choose one of four image areas here.
A rectangle can be drawn, using the sliding control with "TOP", "BOTTOM",
"LEFT" and "RIGHT", which is then monitored for movement.
If a movement occurs within the rectangle, the rectangle fl ashes.