Starting Work With The Spray Attachment - WAGNER W 950 FLEXIO Mode D'emploi

Masquer les pouces Voir aussi pour W 950 FLEXIO:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

W 950 Flexio
W 950 Flexio
The following chapters 20-26 describe working with vinyls and lacquers with
i
the spray attachment.
Read chapters 9-19 if you want to use wall paint with the W 950.

20. Starting work with the spray attachment

Put the machine down only on a level,
clean surface.
Before connecting to the mains supply, be
sure that the supply voltage is identical
with the value given on the rating plate.
Plug in the power cable.
Aligning suction tube. (Fig. 16)
If the suction tube is positioned correctly,
the container contents can be sprayed
without almost any residue.
When working on lying objects: Turn
the suction tube forwards. (Fig. 16 A)
Spraying work when working on overhead
objects: Turn the suction tube rearwards.
(Fig. 16 B)
Set the container on a sheet of paper, pour
in the prepared coating material.
Screw the container tightly onto the spray
gun
Connect gun handle and spray attachment
together. (fig 17).
If already attached, remove the air hose from
the grab handle of the spray lance.
Only the air hose is required for
i
operating a spray attachment
with the W 950. To facilitate
handling, the material hose can
therefore be removed from the
air hose and the suction hose
can be detached from the basic
unit.
A
A
GB
D
B
click
49
49

Publicité

Table des Matières
loading

Table des Matières