Operation; Presentation; Software Version - socomec ATyS 6m Notice D'utilisation

Automatic Transfer Switch

OPERATION

ATyS 6m

Presentation

The product allows:
• sources control,
• automatic transfer control in AUT mode,
• parameters configuration,
AUT
Led is on when automatic mode is active.
Sources state
- Led is on : source = OK
- Led is off : source is not available.
Operational modes
- Automatic sequence simulator
(test on load)
- Genset remote start (test off load)
- Changeover switch position
control (local or remote).
Changeover switch position indication
Position O, I or II.
Manual operation
• Insert handle
• Only possible in mode,
not padlocked.

SOFTWARE VERSION

Displayed after reset.
(3 minutes power off action to allow the reset).
90
ATyS
LCD
Large display.
Switch state
2 green leds:
- switch I state
- switch II state
Led is on when switch is closed
Yellow led (O) is on when both switches are
opened.
Presentation
Operational modes
Programming
Operation
Visualisation
Automatic sequences
• voltage and frequency metering,
• system state display,
• alarm or fault indication,
Padlock
Yellow led is on when
product is padlocked.
Keypad
Operations
LCD & leds test
Escape
• Insert key
• Turn right for AUT mod
• Turn left for
Padlock
• Only possible in O position (1 and 2 as option)
• Remove handle
• Pull padlocking mechanism to allow
Product Version
number
FAULT led
Led is on where product is faulty.
Disconnect power supplies to
reset.
POWER led
Green led is on when product is
powered.
Navigation
Validation
Key switch (selector)
mod.
padlock insertion.
SOCOMEC - Réf. : 532 211 F