Maintenance And Cleaning - Teuco ARJA Manuel De L'utilisateur

EN

MAINTENANCE AND CLEANING

Your bio-sauna and Finnish sauna ARJA is built with the best materials available on the market.
All maintenance and cleaning operations must be carried out with the product off and cold.
BURN AND FIRE HAZARD! DO NOT CARRY OUT MAINTENANCE AND CLEANING INTERVEN-
TIONS WHILE THE PRODUCT IS WORKING OR IF IT WAS RECENTLY USED. The resistances and
parts subject to overheating must be cold. Product power supply must be interrupted.
STOVE
The heater is built with materials protected against corrosion. For a longer life, carry out periodic maintenance
interventions. Clean the stove accessible surfaces with a soft cloth. If necessary, use a cloth soaked in alco-
hol to clean the inner surfaces of vaporiser, and then wipe them, especially in the event perfumed essences
were poured into evaporator tank by mistake. Carry out decalcification interventions on a regular basis.
STONES FOR SAUNA
The stone for sauna is a natural product. Check the stone pieces are clean, as strong concentrations of
essences may be aggressive, decomposing them. Rinse the stones supplied under current water before
inserting them into the appropriate container. Load the stove with stones evenly, making sure there is space
enough for passage of air and that resistive elements are covered. Do not add oils or additives to water to
wet stones, if not specifically intended for this purpose. Teuco declines all responsibility for any damage aris-
ing therefrom.
VENTILATION OPENINGS
Always check ventilation openings are free and clean. Openings are essential for the proper functioning of
the product, therefore are to be checked on a regular basis, removing any obstruction, if necessary.
DECALCIFICATION OF THE EVAPORATOR
If water used to fill the evaporator is soft, that is <20°F, the evaporator usually works freely and must be des-
caled only in case of need. In case of hard water, it is recommended to carry out descaling on a regular basis.
Pour the descaling agent into evaporator water, bring the mixture to the boil for approximately 10 minutes,
and then allow it to cool. Discharge then the evaporator mixture and rinse with clean water at least twice.
WOODEN SURFACES
Clean the wooden surfaces with a damp cloth. The high temperatures ensure a self-cleaning and conserva-
tive action of product wooden parts. Do not use protective coatings or substances for any kind of cleaning.
IT is important to keep wood dry and protect it against woodworms and moulds.
After the use of product in Bio-sauna mode, it is strongly recommended to carry out a sauna cycle at the
highest temperature and with the minimum humidity to dry surfaces.
Teuco declines any responsibility for damages caused to product surfaces.
34