Teuco ARJA Manuel De L'utilisateur page 29

The parameter values may be modified through
keys and ; you move from a parameter
to another, and from hour to minute, through the
keys and .
The first screen automatically proposes the
start and stop times.
• start time: hour and minutes rounded up
to "5 following minutes".
Ex. current time 10:52  start time 10:55;
10:56  11:00; 09:39  09:40.
• stop time: 6 hours after start.
Ex. start 12:15, stop 18:15.
If the start time is set earlier than the current
one, it is deemed to be programmed for next
day.
If the user set duration above 6 hours, FW
automatically correct the stop time to make it
fall within the allowed range.
Every time a key is pressed in the function, a
tout of 5" is initialized.
The max. start time it the current time plus
23h:55'.
The max. stop time is the start time plus 6
hours (max. function duration).
Pressing the key briefly saves the parameters
set, the key blinks in BLUE 1"ON/1"OFF (to
indicate the programming is active), and, while wait-
ing for the time to elapse, inhibit further modifica-
tions.
Wait the tout end to exit the function.
When tout elapses:
• You return to "FUNCT. ON" or "READY" mode
depending on whether the chromotherapy func-
tion is active or not.
Once the AUTO mode has been programmed:
• it can be cancelled by pressing the key
"READY" mode, press the key
• it can be modified by repeating the same procedure and overwriting the current setting (from "FUNCT.
ON" or "READY" mode, press the key
• the activation in manual mode is not allowed.
for 1.5" in the AUTO config. screen (from "FUNCT. ON" or
);
);
EN
29