Instructions For Use Main Functions; Preliminary Operations; Power The Electric System Up - Teuco ARJA Manuel De L'utilisateur

INSTRUCTIONS FOR USE
MAIN FUNCTIONS

PRELIMINARY OPERATIONS

POWER THE ELECTRIC SYSTEM UP

Position the main switch/disconnecting switch to
ON, predisposed in installation phase.
The display backlight goes on at low intensity.
The "TEUCO" logo is shown on the display; all LEDs
are off and no key is active.
This phase has a minimum length of 8" (max 12" in
case of failure to communicate).
During this phase, the presence of the following
alarms is verified:
Failure to communicate between
E1_1
keypad and sauna power
E2_1 Sauna power: Thermal fuse open
Sauna power: Faulty temperature
E2_2
probe
E3 Keypad: EEPROM memory fault
After the starting phase, without any other alarm
active and when no automatic switching on is pro-
grammed, the "READY" status is entered, where
date, time and temperature are shown for a few mo-
ments.
In this initialization phase, chromotherapy may go
on automatically for few moments, and then turn off
in automatic.
The system then enters the stand-by phase, where
the display is off and the ON/OFF button
at low intensity.
is lit
EN
11