Sibelmed Somnibel Pro Manuel D'utilisateur page 46

Recorded signals
Compliance records
Compliance Enhancement Settings (Notes 4, 5)
Auto-adjusting Stimulus Levels
EasySleep Delay
Supine Delay
Stimulus Increase Period
Time at Maximum Power
Supine threshold angle
Visual indications (Note 6)
Notes:
1. Maximum temperature is restricted to 37ºC only when the device is used during the treatment (with the adhesive). Thus, the temperature on the adhesive will be below 40ºC (maximum
recommended temperature for the adhesive) and below 41ºC (according to EN60601-1 standard). 2. Transport and storage conditions of the device are reduced with respect to the IEC 60601-
1-11 standard due to the specifications of the internal lithium –polymer battery, vibration motor and switches. 3. Values measured at a distance of 0.25 m for the maximum intensity level with
a test method equivalent to ISO 3744:2010. 4. See section COMPLIANCE ENHANCEMENT SETTINGS for definitions. 5. The values for
software. The factory default values are the same as the
EN 19
Somnibel
--
--
15 min
30 secs
60 secs
20 min.
45º
Device Turn ON / Device Turn OFF
Device running / Low battery
Charging battery / Self-Test error
Incorrect Clipping
Somnibel device. 6. See section VISUAL INDICATIONS AND WARNINGS.
Somnibel Pro
Sleeping position / Actigraphy / Stimulus power (up to 36 records
and up to 10h/record)
Up to 365 records
0%, 25%, 50%, 75%, 100% (< 110 dB)
Device Turn ON / Device Turn OFF
Device running / Low battery
Charging battery / Self-Test error
Incorrect clipping / Memory low (<10h)
Memory full / Memory Error
Somnibel Pro
somnibel Pro
User's Manual
0 to 60 min
0 to 60 secs
30 to 300 secs
2 to 120 min
30º to 75º
can be programmed through the SomniLab
534-80P-MUM_Rev.1.08